Biggified Ork Battlewagon Pt 5

After a couple of weeks off to work on a 50 hour trivia marathon, I’m back. (whew)

I’ve actually puttered my way through the last month with short spurts of work here and there, not enough in one sitting though to make a difference. The biggest difference is in the back, closing up the rear entrance and finishing off the tailgate. I’m adding a boarding plank from the trukk kit to one side and I’m dithering between another small platform on the other side or a large set of exhausts (I’m leaning towards exhausts). I also close up the gap between the wheels up front wit ha rhino door plate. Worked pretty well.

I’m trying to figure out the best way to get a sort of “running board” over the front wheels that mesh/weld into a platform that extends from the doors to put two big shoota “nests” out the side doors. This way, my four big shootas setup has two out of the back bed and one out of each door. This should give my expected Kill Kannon (scratch built, of course) so be a nice focal point when installed, yet give the wagon a nice low, lean look when not using the kill kannon.